If you have been reading about RP-HPLC and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-09-22. Where a claim depends on a specific study, the study is described rather than over-claimed.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers |
| Typical storage temperature | -20 °C | Dry, desiccated, protected from light |
| Typical analytical method | RP-HPLC with UV detection | Often paired with LC-MS |
| Water content | Reported as Karl Fischer value | Freeze-dried material is hygroscopic |
=== Unsupported health claims === In 2010 a panel of the European Food Safety Authority examined health claims made for whey protein. For the following claims either no references were provided for the claimed effect or the provided studies did not test the claims, or reported conflicting results:
== Herbal == Eryngium planum is used in European folk medicine as a diuretic, a stimulant, and an appetizer owing to its essential oils, and bioactive compounds, and in this usage it may be known as Eryngii plani herba or Eryngii plani radix.
Bacterial infections may be treated with antibiotics, which are classified as bacteriocidal if they kill bacteria or bacteriostatic if they just prevent bacterial growth. There are many types of antibiotics and each class inhibits a process that is different in the pathogen from that found in the host. For example, the antibiotics chloramphenicol and tetracyclin inhibit the bacterial ribosome but not the structurally different eukaryotic ribosome, so they exhibit selective toxicity. Antibiotics are used both in treating human disease and in intensive farming to promote animal growth. Both uses may be contributing to the rapid development of antibiotic resistance in bacterial populations. Phage therapy, using bacteriophages can also be used to treat certain bacterial infections.
Sources: en.wikipedia.org
Central obesity: waist circumference ≥102 cm (40 in) men; ≥88 cm (35 in) women Dyslipidaemia: TG ≥1.7 mmol/L (150 mg/dL) Dyslipidaemia: HDL-C <40 mg/dL (men), <50 mg/dL (women) Blood pressure ≥130/85 mmHg (or treated for hypertension) Fasting plasma glucose ≥6.1 mmol/L (110 mg/dL)
=== Skin health === The estrogen receptor, as well as the progesterone receptor, have been detected in the skin, including in keratinocytes and fibroblasts. At menopause and thereafter, decreased levels of female sex hormones result in atrophy, thinning, and increased wrinkling of the skin, and a reduction in skin elasticity, firmness, and strength. These skin changes are an acceleration in skin aging and are the result of decreased collagen content, irregularities in the morphology of epidermal skin cells, decreased ground substance between skin fibers, and reduced capillaries and blood flow. The skin also becomes more dry during menopause, as a result of reduced skin hydration and surface lipids (sebum production). Along with chronological aging and photoaging, estrogen deficiency in menopause is one of the three main factors that predominantly influences skin aging. Hormone replacement therapy, consisting of systemic treatment with estrogen alone or in combination with a progestogen, has well-documented and considerable beneficial effects on the skin of postmenopausal people. These benefits include increased skin collagen content, skin thickness and elasticity, and skin hydration and surface lipids. Topical estrogen has been found to have similar beneficial effects on the skin. In addition, a study has found that topical 2% progesterone cream significantly increases skin elasticity and firmness and observably decreases wrinkles in peri- and postmenopausal people.
Many different emulsifiers are used in pharmacy to prepare emulsions such as creams and lotions. Common examples include emulsifying wax, polysorbate 20, and ceteareth 20. Sometimes the inner phase itself can act as an emulsifier, and the result is a nanoemulsion, where the inner state disperses into "nano-size" droplets within the outer phase. A well-known example of this phenomenon, the "ouzo effect", happens when water is poured into a strong alcoholic anise-based beverage, such as ouzo, pastis, absinthe, arak, or raki. The anisolic compounds, which are soluble in ethanol, then form nano-size droplets and emulsify within the water. The resulting color of the drink is opaque and milky white.
== Synthesis == The glycosylation of proteins has an array of different applications from influencing cell to cell communication to changing the thermal stability and the folding of proteins. Due to the unique abilities of glycoproteins, they can be used in many therapies. By understanding glycoproteins and their synthesis, they can be made to treat cancer, Crohn's Disease, high cholesterol, and more. The process of glycosylation (binding a carbohydrate to a protein) is a post-translational modification, meaning it happens after the production of the protein. Glycosylation is a process that roughly half of all human proteins undergo and heavily influences the properties and functions of the protein. Within the cell, glycosylation occurs in the endoplasmic reticulum.
Sources: en.wikipedia.org
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.
Dry lyophilised powder is generally kept at minus twenty degrees Celsius, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they encourage aggregation and moisture uptake. Solutions are less stable than the solid form and degrade faster at room temperature.
A certificate documents what the supplier measured, not what an independent party confirmed. Methods, instruments and acceptance criteria can differ between suppliers. Third-party testing is the usual way to resolve discrepancies.
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.