Reversed-phase HPLC raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2025-08-09 and is reviewed periodically as new material appears.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
The compound is registered in Russia as a pharmaceutical product, most commonly formulated as a nasal solution, and has been used in that setting since the 1990s. Outside that jurisdiction it is generally handled as a research chemical rather than an approved medicine. Regulatory status therefore differs sharply between countries, and material sold internationally may not correspond to the Russian pharmaceutical formulation. Documentation with commercial samples is typically limited to a certificate of analysis covering purity and identity, not clinical status or local legal classification.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | ≥ 95 % of peak area by HPLC | Some suppliers quote 98 % or higher |
| Identity confirmation | Mass spectrometry (electrospray or MALDI) | Observed mass is compared with the calculated mass |
| Common analytical method | Reversed-phase HPLC on a C18 column | Acetonitrile and water gradients with trifluoroacetic acid |
| Primary degradation route | Oxidation of the methionine residue | Yields a sulfoxide that separates cleanly on chromatography |
| Storage of dissolved material | Aliquoted and frozen at −20 °C or below | Single-use aliquots avoid repeated temperature cycling |
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Identity and purity are commonly assessed by reversed-phase high-performance liquid chromatography, with ultraviolet detection near 214 nanometers for the peptide backbone. Mass spectrometry, either electrospray or matrix-assisted laser desorption, confirms molecular mass and detects truncation or modification products. Amino acid analysis can verify composition. Because the sequence contains no strongly absorbing aromatic residue apart from phenylalanine, detection wavelengths are chosen carefully. Purity values above 95 percent are typical for research-grade material.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Clinical reports describe use in ischaemic stroke, transient ischaemic attack, optic nerve conditions, and cognitive complaints, but most of these studies are small and were conducted in a single region. Systematic reviews have generally described the evidence base as limited in size and variable in methodological quality. Randomised controlled data suitable for international regulatory assessment are scarce. As a result, major treatment guidelines outside Russia do not include the peptide, and interest in it remains largely research-driven rather than routine clinical.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
Semax binds to melanocortin receptors and is thought to influence neuronal survival and plasticity rather than to act through the adrenal axis. Laboratory work has shown increased expression of brain-derived neurotrophic factor and nerve growth factor in treated tissue. Changes in c-Fos, a marker of neuronal activation, have also been reported. Because the peptide is rapidly degraded by peptidases, its effects are generally attributed to downstream signaling cascades rather than to sustained receptor occupancy.
Published studies are dominated by animal models of stroke, ischemia, and cognitive impairment, with a smaller number of human trials conducted in Russia. Many of the human reports are small, single-center, and published in Russian-language journals, which limits independent scrutiny. Outcome measures vary between studies and often rely on clinician-rated scales rather than objective biomarkers. Systematic reviews have noted the methodological weaknesses and called for larger, preregistered trials before firm conclusions can be drawn.
Claims about enhanced focus, memory, or mood in healthy people rest mostly on anecdotal reports and community discussion rather than on controlled data. It remains unclear whether any cognitive benefit observed in patients recovering from brain injury would extend to uninjured users. Dose-response relationships, long-term safety, and interactions with other drugs are not well characterized in the peer-reviewed literature. Questions about optimal route of administration and treatment duration likewise remain open.
Development is attributed to researchers at the Institute of Molecular Genetics in Moscow during the early 1980s, building on earlier Soviet work with ACTH fragments. Russian regulatory approval followed for intranasal use, and the compound has remained commercially available there for decades. Most published human data originate from Russian and, later, some Eastern European clinical reports, which are not always accessible in English translation. Outside that region the material is generally handled as a research chemical rather than a licensed medicine.
Regulatory status differs sharply between jurisdictions. In Russia the peptide is registered as a prescription nasal preparation, while agencies such as the United States Food and Drug Administration have not approved it for any indication. Products sold elsewhere are typically labeled for laboratory research only, and such labels shift responsibility for safe handling to the purchaser. Because the same name covers pharmaceutical-grade nasal drops and bulk research powder, identity and purity documentation becomes the main practical concern when comparing sources.
== Blood tests == Bilirubin is degraded by light. Blood collection tubes containing blood or (especially) serum to be used in bilirubin assays should be protected from illumination. For adults, blood is typically collected by needle from a vein in the arm. In newborns, blood is often collected from a heel stick, a technique that uses a small, sharp blade to cut the skin on the infant's heel and collect a few drops of blood into a small tube. Non-invasive technology is available in some health care facilities that will measure bilirubin by using a bilirubinometer which shines light onto the skin and calculates the amount of bilirubin by analysing how the light is absorbed or reflected. This device is also known as a transcutaneous bilirubin meter. Bilirubin (in blood) is found in two forms:
=== Melting and boiling properties === Organic compounds typically melt and many boil. In contrast, while inorganic materials generally can be melted, many do not boil, and instead tend to degrade. In earlier times, the melting point (m.p.) and boiling point (b.p.) provided crucial information on the purity and identity of organic compounds. The melting and boiling points correlate with the polarity of the molecules and their molecular weight. Some organic compounds, especially symmetrical ones, sublime. A well-known example of a sublimable organic compound is para-dichlorobenzene, the odiferous constituent of modern mothballs. Organic compounds are usually not very stable at temperatures above 300 °C, although some exceptions exist.
Structural proteins confer stiffness and rigidity to otherwise-fluid biological components. Most structural proteins are fibrous proteins; for example, collagen and elastin are critical components of connective tissue such as cartilage, and keratin is found in hard or filamentous structures such as hair, nails, feathers, hooves, and some animal shells. Some globular proteins can play structural functions, for example, actin and tubulin are globular and soluble as monomers, but polymerize to form long, stiff fibers that make up the cytoskeleton, which allows the cell to maintain its shape and size. Other proteins that serve structural functions are motor proteins such as myosin, kinesin, and dynein, which are capable of generating mechanical forces. These proteins are crucial for cellular motility of single celled organisms and the sperm of many multicellular organisms which reproduce sexually. They generate the forces exerted by contracting muscles and play essential roles in intracellular transport.
Sources: en.wikipedia.org
Soy sauce allergy not caused by soy or wheat allergy is rare. Most varieties of soy sauce contain wheat, to which some people have a medical intolerance. However, protein hydrolysis (fermentation or industrial) breaks down gluten, so some soy sauces may end up tolerable to gluten-intolerant individuals with no detectable gluten left. Japanese tamari soy sauce is traditionally wheat-free, and some tamari available commercially today is wheat- and gluten-free. Acid-hydrolyzed vegetable protein is non-allergenic due to the completeness of protein breakdown.
== Contributions to yachting == In retirement John Knox pursued his lifelong interest in yachting, applying scientific rigour to the field of anchoring. He invented the Anchorwatch, a strain gauge which measures the force on an anchor chain, in order to alert crew when their anchor is at risk of slipping during a stormy night. Knox used the Anchorwatch device to establish a testing procedure for measuring an anchor's holding force, and conducted years of experiments on Scotland's beaches to measure the efficiency of most anchor designs available on the global market. His work on anchor testing culminated in the design of his own optimised Knox Anchor, now commercially manufactured in the UK.
Essendon Hall of Fame Legends (year inducted): Bill Brew (2013), Bill Busbridge (1996), Jack Clarke (1996), John Coleman (1996), Bill Cookson (1996), Wally Crichton (2010), Terry Daniher (1996), Barry Davis (2006), Ron Evans (2012), Tom Fitzmaurice (1996), Ken Fraser (1996), Allan Hird Sr (1996), James Hird (2011), Harry Hunter (2015), Bill Hutchison (1996), Matthew Lloyd (2013), Simon Madden (1996), Alex McCracken (1996), Michael Long (2010), Howard Okey (2012), Frank Reid (1996), Dick Reynolds (1996), Greg Sewell (2009), Kevin Sheedy (2008), Albert Thurgood (1996), Tim Watson (1998), Neale Daniher* (2018), Dustin Fletcher*, Dr Bruce Reid* (2014), Gavin Wanganeen* *denotes recent elevation to Legend status Essendon Hall of Fame members (year inducted): Noel Allanson (2015), Fred Baring (2013), John Birt (2010), Reg Burgess (2015), Wally Buttsworth (2010), Barry Capuano (2014), Kevin Egan (2015), Alec Epis (2014), Ken Fletcher (2011), Keith Forbes (2010), Garry Foulds (2010), Darryl Gerlach (2013), Mark Harvey (2014), Bruce Heymanson (2013), Jack Jones (2012), Ron Kirwan (2016), Harold Lambert (2018), Scott Lucas (2013), Roy McConnell (2013), Don McKenzie (2010), Roger Merrett (2018), Joe Misiti (2012), Hugh Mitchell (2012), Graham Moss (2012), Gary O'Donnell (2014), Dr Ian Reynolds (2018), Paul Salmon (2012), David Shaw (2011), Arthur Showers (2010), George Stuckey (2010), Hugh Torney (2011), Paul Vander Haar (2015)
=== Amputation methods === Throughout Europe, there were varying approaches when it came to amputations. The two main considerations for amputation procedures were how fast it could be performed and how it would heal. The mallet-and-wedge technique involved setting the body part on a wedge and hitting the wedge with a mallet. This separated the limb or digit from the body by crushing it. This method was very fast but left a messy result that caused the crushed bones to splinter into the remaining part of the limb. The hand's-width method used a curved knife to cut through the limb's tissue, and a bow-frame saw to cut through the bone. An assistant would pull the flesh upwards to expose the bone. After the limb was sawed off, the flesh would then be pulled back over the stump to create a cushion. This procedure took longer but healed more easily. One method to stop hemorrhaging after amputation was iron cautery. This involved taking hot iron instruments to the new stump and burning off the exposed tissue, closing the blood vessels. Another method of cauterization was to apply corrosive chemicals to the fresh wound to burn the blood vessels and stop the bleeding. Both methods were efficient but led to a long healing process. A different method was ligation. This technique required the surgeon to draw out the individual blood vessels and tie them shut. This process was much more time-consuming but healed more quickly. There was also debate among barber-surgeons on the location of amputation.
Sources: en.wikipedia.org
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.
The methionine residue at the start of the chain is vulnerable to oxidation, producing a sulfoxide variant. Amide bonds can also hydrolyze, though more slowly under neutral conditions. Cold storage, oxygen exclusion and minimization of freeze-thaw cycles slow both processes but do not stop them.
A purity number on a certificate does not establish that a powder is the same product as a registered nasal medicine. Counter-ion content, residual solvents and peptide-related impurities may differ between the two. Independent verification is the only way to narrow that gap.
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.